(Amended by Ordinance No. 179690, effective November 18, 2005.) The Director
shall conduct the following inspections on permitted development activities. It
shall be the duty of the responsible party to notify the Director at the
appropriate inspection phase as set forth below. Inspections of erosion,
sediment and pollutant control measures may occur with other inspections being
conducted on the development or construction project.
A. Pre-construction inspection. The Director shall conduct
inspections after initial, temporary erosion, sediment and pollutant control
measures have been put in place and prior to any ground disturbance in addition
to that necessary for the installation of the erosion, sediment and pollutant
control measures. When the development is being conducted in phases, this
inspection shall occur at the beginning of each phase.
B. Permanent measures inspection. The Director shall conduct
inspections after permanent measures are put in place. When the development is
being conducted in phases, this inspection shall occur after permanent measures
have been installed for each phase.
C. Interim inspections. The Director may conduct other
inspections not specifically addressed above to determine compliance with this
D. Final erosion control inspection. For special sites as
defined in Section 10.30.030 A., an inspection shall be conducted after
construction completion to determine the effectiveness of permanent erosion and
sediment control measures. This inspection shall be conducted six months after
construction completion or at other times determined by the Director. This
inspection may be conducted at sites other than special sites as determined by